← Darsh Patel

Dual-rotor axial flux motor

Personal · Summer 2026

On this page

A dual-rotor axial flux motor that I worked on over Summer 2026, with 3D-printed parts. A ring of wound stator teeth sits between two rotor discs, around a central hub.

The stator coils are hand-wound with magnet wire on 3D-printed bobbins. To drive them I built a half-bridge on perfboard, with an IR2110 gate driver switching two TO-220 FETs, and a second perfboard carrying two LM2596 buck converter modules for the supply rails.

CAD render of the motor: the stator teeth arranged in a ring around the hub, between the two rotor discs.
CAD render of the motor: the stator teeth arranged in a ring around the hub, between the two rotor discs.
Three stator coils wound on printed bobbins, the IR2110 half-bridge board (top) and the board with two LM2596 buck modules (bottom).
Three stator coils wound on printed bobbins, the IR2110 half-bridge board (top) and the board with two LM2596 buck modules (bottom).
The back of the half-bridge board, with the point-to-point solder traces.
The back of the half-bridge board, with the point-to-point solder traces.